martoli
Member
Last Activity: Today, 04:03 PM
Joined: 08-10-2010
Location:
-
Blowback start puts the Hi-Frequency and air switch start on the PC Board with no need to manually adjust the spark gap like the older plasma machines. -
That machine in the Plasma section of it appears to be similar to the Miller ZipCut 40 plasma machine torch. I see the designation of 404040-I on that machine which would give each mode of operation 40amps in and 200amp out performance. That torch requires the third Hi Frequency connector like the...
Leave a comment:
-
This particular torch(3 wire) should work as a replacement Plasma torch for your machine. Regards. ...
Leave a comment:
-
That unit is similar to the Miller ZipCut Series 40 amp Plazma Cutter. Except this is a welder gone plasma. A 40 amp plasma torch with a switch on handle should work. Search E-Bay for 40 amp plasma torch. Will need threaded torch/air connector. ...Leave a comment:
-
Hobart GF-250 and GR-303 wiring Difference
Hello it's been ages since been here. Surprised that this Forum is still here. I'm wondering what the Circuit difference between the GF-250 Ford Six welders have between them. I notice that the Maximum OCV for the GF-250 is 90v and the max OCV for the GR-303 is only 40v. Is there a way to wire the GF-250...
No activity results to display
Leave a comment: