Announcement

Collapse
No announcement yet.

User Profile

Collapse

Profile Sidebar

Collapse
Profile Picture
snoeproe
Senior Member
Last Activity: 04-20-2019, 03:50 PM
Joined: 04-13-2008
Location: North West Ontario Canada
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • One thing I’ve had problems with in the past is large gas nozzles on mig guns that can potentially restrict your travel of path vision.
    For groove welds I prefer a tappored contact tip and nozzle. It allows so much better visibility for travel and allows me to get further into a groove with...
    See more | Go to post

    Leave a comment:


  • snoeproe
    replied to P&H Welder
    Jason
    there should be an identification tag on the machine somewhere. On it should be a primary and secondary power rating. The primary rating will be input power requirements for the machine. The secondary rating will be the output power of the machine.
    This tag will tell you everything...
    See more | Go to post

    Leave a comment:


  • snoeproe
    replied to Hobart Hefty Feeder
    No. The hefty feeders are push only feeders.
    Pretty sure the cobramatic is a push/pull feeder ?...
    See more | Go to post

    Leave a comment:


  • snoeproe
    replied to Would this pass?
    If your just learning how to weave with stick, your going in the right direction. I don't see undercut on the toes, that's good. Consistency needs a little improvement. Restarts need a little work. The bottom where you started is a little under filled. Don't be afraid of using more heat....
    See more | Go to post

    Leave a comment:

No activity results to display
Show More
Working...
X