Hunter55
Senior Member
Last Activity: 06-22-2021, 12:23 PM
Joined: 07-24-2014
Location: Northern Colorado
-
I have used my 140 on my 5000 running watt generator without any issues at all. I would run several long beads [6 inches or more] non stop and it has never tripped the breaker. My settings are 3 on voltage and wire speed is between 4 and 5 and most always closer to 4. I have welded many times on 5/16... -
As a former driver for a major steel fabrication shop in northern Colorado, I often delivered material that was tagged as such. It is always written on the drawings to tag with a special designed tag. It is a requirement as per The AWS and the steel fabrication engineering community / profession.Leave a comment:
-
I had a similar problem with my plasma cutter. I did everything you did as far as checking etc. etc. The problem turned out to be a break in the ground cable that was not visible. The cable somehow got pinched hard enough to break the wire but not the insulating coating. I found the break by rubbing...Leave a comment:
-
You didn't mention the spool gun switch. ???????????Leave a comment:
No activity results to display
Leave a comment: