...
T>D>C
Senior Member
Last Activity: Yesterday, 08:40 PM
Joined: 09-20-2003
Location: East Texas
-
New Hobart Welder? What's this?
Perusing on line when I noticed this photo of a engine driven Hobart welder on the Cyberweld website. It looks like it has a built in compressor. The control face has two controls. It has Hobart on the side. Anyone notice that before? It is not listed as an option on the Hobart website.
... -
Sheet metal screws provided by the sheet metal supplier driven into the 1” square tubing purlins I welded to the trusses.Leave a comment:
-
4 of 14 sheet metal panels up. ...
Leave a comment:
-
All the purlins for sheet metal welded in. Brushing out and painting the welds now.
I need to figure out what to do about the vent/skylight. I would like to prep that before hanging sheet metal but maybe not... ...Last edited by T>D>C; 10-16-2020, 10:31 PM.Leave a comment:
-
4 purlins up. Picked up the sheet metal today. Finished the welds on all vertical supports....Leave a comment:
-
Cleaned and put primer on the 1” square tubing I’m going to Use for purlins. ...
Leave a comment:
-
Yay me! Last truss in the air. Leveling, finishing up the welding and bracing. More brushing and painting. Hope to install sheet metal by next weekend. ...
Leave a comment:
-
Hung the last joist. Last truss tomorrow....
Leave a comment:
-
4th truss hung tonight. Hopefully install last joist and truss this weekend. Sheet metal roof next weekend....Leave a comment:
-
4...
Leave a comment:
-
Noted Northwelder. Either way, I will keep you posted on their performance. I ordered the sheet metal today. 26 gauge R-Panel. 3 trusses up. Hopefully I have the sheet metal on by the end of next weekend. Weather coming on Friday so there may be delays. Maybe date night Friday night!Leave a comment:
-
Long day today but was able to get a truss up and secure. Dark set in and shut me down. 4 of 5 joist installed. Welding not complete and I have some fitting repair work to do but I wanted to get a truss up to see what it’s going to look like....Last edited by T>D>C; 10-04-2020, 09:33 PM.Leave a comment:
-
Leave a comment:
-
Baby Jake came over to help me hang some joist. We hung two of five. Apparently my pipe fitting skills need work....
Last edited by T>D>C; 10-04-2020, 05:56 AM.Leave a comment:
-
No, if you think it’s ok. I was wondering about the low traffic. Haven’t been here in a few years.Last edited by T>D>C; 10-04-2020, 09:47 AM.Leave a comment:
-
Hobart Expert - Is Archive a good place to start threads?Leave a comment:
-
Leave a comment:
-
Thanks Mac...Leave a comment:
-
Leave a comment:
No activity results to display
Leave a comment: