Pulser settings for DX 200

[DEA]

Can someone give some of the pulser setup settings for the dynasty Dx 200?
For aluminum and stainless .050,1/16 and1/8.
Then I think I'll have a better understadningof how to set it up.
Thanks again
DEA

[Roger]

This link will calculate pulse settings.
Same as MIG door chart it is only starting point.

http://www.pro-fusiononline.com/welding/pulseparams.asp

[Ed in Ga]

DEA,
Not much real info available on pulsing. Some say to use 50% background to peak with 50% on time and others 20% background to peak. Like Roger stated these are only starting points. The Thermal 300 amp inverter uses a fixed pulse of 20% background to peak with 35% peak on time. Used this with a T/A185 with pulse freq of 1.5 Hz on 1/16 Al and it gave me a little better control of things. Haven't had much to time to work with it a lot.

Obviously peak amps must be higher than normal amps for a non pulsed weld. Also changing any one parameter makes a lot of difference.

Good luck and I would be interested in hearing what you find.

Ed