Announcement

Collapse
No announcement yet.

Handle 140 won't feed wire

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Handle 140 won't feed wire

    I press the trigger and hear a loud click but no feed... trying to determine if it's the motor or circuit board

  • #2
    You can disconnect the motor from the circuit board and use 12 volt battery to try and power the motor, if motor runs its probably a problem with circuit board... If motor does not run, well its probably the motor...

    Dale
    "Fear The Government That Wants To Take Your Guns" - Thomas Jefferson..

    Comment


    • #3
      Make sure the unit's voltage selector switch is clicked into a numbered position and not between ranges. If you have an older one make sure it is not in purge as well.

      Comment

      Working...
      X