If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I'm having a problem with the wire feeding too quickly on my Hobart 125 EZ. Is there any way to adjust the wire feed speed on that welder?
Thanks,
Mike
Thanks Darrell,
I didn't get any paperwork with the welder when I bought it from Tractor Supply. I've been wasting a lot of wire because it is pushing it out so fast.
Mike
Comment