Announcement

Collapse
No announcement yet.

Question

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Question

    I have a Champion 10000. The other day I went to use it and I had no arc at all. This is the first machine I have had that was not a Lincoln, so I went and twisted the amp knob two or three times (it had been sitting a while). The next time I tried it it went to full amperage almost bogging the engine completely down.

    I have read the other thread about the circuit board but since I started with no current at all then messed up after I fiddled with the Rheostat could it be that instead of the circuit board. I would hate to pay all that then find out it was a 30 or 40 dollar item broke.

    Oh by the was howdy ya'll new here to the board
    Last edited by livininlogs; 10-27-2008, 06:37 PM.

  • #2
    Call the toll-free technical support number 800-332-3281. One of our service techs will help you out.

    Comment


    • #3
      Thanks Darrell

      Comment

      Working...
      X