Announcement

Collapse
No announcement yet.

Hobart 125

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Hobart 125

    Hi all and happy for the add! I have a question on my Hobart 125 , it’s not feeding wire, I made sure the roller is on the knurled side for flux core wire , as soon as any pressure is applied the shaft that turns the bottom roller stops , any advice, thanks in advance

  • #2
    It feeds wire down the cable but stops with resistance? How much? How fast can you feed the wire without resistance? Did it work fine before this issue or did you acquire it like this? Does it weld (which should be very low resistance to wire feeding)?

    Comment


    • #3
      Thanks everyone, I figured out the problem, it was the wire drive motor, thanks!!!!

      Comment

      Working...
      X