Announcement

Collapse
No announcement yet.

Lincoln K814 arc start

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Lincoln K814 arc start

    Does any one have any information on hooking a K814 to a powcon 300st. I think the 814 has a 6 wire harness and the 300 has a 14 pin conn. Is there an adapter? Does anyone have a layout of the 14 pin they can send me or direct me to. I have spent hours researching this to no avail. Help!

  • #2
    any luck finding info on that setup?? I just bought a bunch of junk from a guy and in it was a powcon 300se. I also got a lincoln hi-frequency box. The powcon is missing a control board and I havent got the lincoln box figured out yet. I found that arc-products will e-mail diagrams, and will sell the manual for the powcon for about $25. I just got the diagram to see if i could find the board. I am looking for board # 101606-001 or 101606-002 its the main control board on the left side with all the molex connectors.

    I could e-mail you the diagram for the 300se if that would help.

    john

    Comment


    • #3
      These guys make adapter cords for about anything. ---Mike---

      http://www.justarc.com/plugs.htm
      BUY AMERICAN... THE JOB YOU SAVE MAY BE YOUR OWN!!!!!

      Hobart Champion 16
      Miller external secondary contactor
      stick foot pedal
      remote voltage control(homemade)
      Hobart Portafeed 17(w AG-2000 control box)
      Bernard Q350 mig gun
      Hobart AG-2000 pull gun
      Lincoln Hi-Freq k799(yes, I know it's red)
      Weldcraft CS300 tig torch
      Miller RFC-23A foot pedal
      Thermal Dynamics Cutmaster 50
      Victor 450/300 series torches
      oodles of connecting cords

      I can fix it, just pay me to replace it first

      Comment

      Working...
      X