Looking for a manual and some parts

[Damifino]

I posted this in Tig welders also. Picked up a Tig Combo AC/DC. I'm looking for a manual and a replacement plasma cut torch. Thanks for the help.

[Damifino]

OK. Got one from Jeff at Hobart Retail Customer Service. It says I need a TP 6A torch so need to start looking. Any ideas if there is a comparable newer number? Thanks

[Damifino]

I need a TP-6A PAC torch complete, or a compatible setup that will work on this machine. Not having much luck finding one. Thanks CJ

[martoli]

That machine in the Plasma section of it appears to be similar to the Miller ZipCut 40 plasma machine torch. I see the designation of 404040-I on that machine which would give each mode of operation 40amps in and 200amp out performance. That torch requires the third Hi Frequency connector like the older Hi frequency start machines. Amazon Carries a replacement torch that will work.

[Damifino]

Thanks martoli. I will look it up.