135 Handler problem

[Dave W.]

I recently bought a used 135 Handler. It is in good shape but the gun needed replaced. I ordered a replacement gun and the end that plugs into the machine is slightly different from the one I have. It is the same length but the gas hole isn't in the same place. Also the new end is slightly bigger than the hole on the machine where it plugs in. Any help will be appreciated

[Dale M.]

Ummm .... What did you order?... Manual states H-10 gun assembly, part # 195 957

Dale

[Hobart Expert Keith]

Current replacement is now the H100S2-10 part number 245924.

[Dave W.]

yep....I'm an idiot........I went on ebay and bought a cheap one that "fits the 135 handler"........lesson learned

[Dave W.]

Still...the one that fit said Miller on the gun handle.....are some universal?

[Hobart Expert Keith]

The original gun would have said Miller on the handle but was not an actual Miller gun. It was a modified M-10 Miller gun with the Hobart power pin which is smaller than the Miller version, thus being called an H-10.