Announcement

Collapse
No announcement yet.

HH140 Replacement Gun Assembly

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Hobart Expert Brian
    replied
    Bobby, smyrna5 is correct, take your H10 gun from your HH180 with you to check out the unit, same gun.

    Leave a comment:


  • Clay Walters
    replied
    http://www.weldingsuppliesfromioc.co...let/Categories

    Leave a comment:


  • smyrna5
    replied
    If the cyberweld ad is correct, you can check it out with your HH 180 gun. The HH 180 literature on this site also seems to say the 180 uses the same gun.
    Last edited by smyrna5; 11-08-2007, 12:33 PM.

    Leave a comment:


  • BDKS
    replied
    Thanks for the ballpark estimate. I think it might be worth going a checking out.

    Leave a comment:


  • smyrna5
    replied
    I seem to recall they were about $100, but they must have hiked the price at cyberweld since I last looked.

    http://store.cyberweld.com/h10miggun.html

    I see some new ones on eBay for about $130, and if you can find one used you could probably get it below $100.
    Last edited by smyrna5; 11-08-2007, 12:17 PM.

    Leave a comment:


  • BDKS
    started a topic HH140 Replacement Gun Assembly

    HH140 Replacement Gun Assembly

    How much would the entire gun and cable assembly cost? I am looking at a hh140 in the paper. It does not look used at all. The cable assembly was broken at the front of the machine. I intend on taking a jumper wire to make sure the contactor, drive motor, etc work.

    Thanks
    Bobby
Working...
X