Hobart g-213 service manual request and advice info

[RandyJHarris]

I am new to the site also, I am in the same situation. I have a G213 given to me from my son that was a barn find, serial number (as best as I can read the plate) 77WSI3215 Spec 5776-1 and I could really use the manual for this to see if I can get it up and running. Any help would be greatly appreciated.

[Pmi1924]

I have the file but it is about 4 MB and I can t load it here. If you send me an email I will attache it to it.
Chuck
[email protected]

[mla2ofus]

Is it the 12v or 24v model?
Mike

[RandyJHarris]

I don't know Mike. as far as i can read the label it says ocv 72 and then volts 25

[RandyJHarris]

I sent you my email address Chuck, thank you very much..

[RandyJHarris]

I have the file but it is about 4 MB and I can t load it here. If you send me an email I will attache it to it.
Chuck
[email protected]

Chuck, it's [email protected] Thank you sir

[RandyJHarris]

Perfect Chuck!!! Thank you very much

[RKC1202]

Hi everyone Same problem you all are having Got a g-213 but need the wiring diagram Can anyone help please. [email protected] thanks in advance

[Tevans9996]

Hello, I have a Hobart G-213, and need any documentation that someone might have for it.
It has the Wisconsin engine and runs and welds just fine. However it has no output from the AC generator. Any manuals would be greatly appreciated. I would like to repair it if possible.
Thank you in advance.
Tim

[mla2ofus]

If yours doesn't have the fuses for the power circuits it likely has the wiring burned out due to a severe overload. I've been told this is common on these. PM me your email add and I'll email them to you. Is yours the 12v or 24volt model?
Mike

[Wallsfour]

Hello . I'm trying to get a G-213 a.c. side to give voltage. It's 12 volt starter and no fuse. Please I'm in need of the manual for it. Thanks for any assistance.

[Hobart Expert]

I'll see if I can get ahold of the manual for this machine.

[Hobart Expert]

If those that need a copy of this manual could PM me your email and spec # of your machine I should be able to send you a copy of the manual.

[Swat]

Could someone please email me the Hobart G213 service manual or tell me where I can download it?

[Hobart Expert]

Please see the last message in this thread. PM me your email and the spec number for your machine.