Hobart g-213 service manual request and advice info

[Prose313]

Ok thanks for the info

[Prose313]

Hi my g213 has a twin wisconsin. I can't find anything about this motor,TJD-spec 325306-serial5452237.

[CoreyBurton]

new to this site, but looks awesome. I am also looking for a repair manual for the Hobart G-213.

[Lazerdealer]

New to the site, very good info so far. I just acquired a g-213 but it has been previously sand blasted so there is no writing on the case anymore and need to know what the switches are for. It generates 110v but haven't tried the welder yet as I didn't get leads with it. Looking for a manual for the unit. Would be much appreciated! Looks very well built. Spec #413OB and serial AAW-58444 can someone e-mail a manual or is it too big?

[Hobart Expert Keith]

Lazer, check your email.

[Pmi1924]

Hello, I am new to this forum too. I am in the same situation as others. I just bought a Hobart G-213 SN AAW-91717 and looking for a manual or any information I can get for it.

[Hobart Expert Keith]

Pmi, Check your email.

[3wincoop]

I am new to this forum and just got my G-213 serial # 80WS03249 running but need a manual. thanks : [email protected]

[mla2ofus]

check your email

[Mainer]

Hi, I just got ahold of a G213 Hobart. Does anyone have a wiring diagram for this machine? It makes AC power and welds with the DC, though the RPMs seem very low while welding. The starter appears to be operated 24v through the gen windings somehow. It is not working. I hand crank started it. Also, that weld and power and standby power switch seemed to do nothing. Was it normal just to manually dial in the rpms to get your volyage on these machines? If so why bother with that switch? A manual for the g213 would help alot! This one has a side mount gas tank, batts on top, and 12A buss fuses for the AC legs on the front panel if that helps to date it. Any tune up I should do electrically on the head not related to the Wisconsin?

[Mainer]

My email is [email protected] if anyone has a wiring diagram or operating manual handy! Thanks in advance!

[mla2ofus]

Check your email.
Mike

[Hobartg213]

hello good day I bought a hobart g213 welding machine I need the electrical or repair manual my email [email protected] please thanks

[Hobart Expert Keith]

Hobartg213, What is your SPEC number?

[mla2ofus]

Hobartg213, What is your SPEC number?

Keith, I sent him the engine manual and asked if he has the 12 or 24v model. Haven't got a reply yet.
Mike